Soleus Air MA-9000AH Owner's Manual page 10

a. Be sure that the drain bucket is properly placed in the unit. If the drain bucket is not
properly secured in the unit, the red "Water Full" light located on the front panel
will blink and the unit will not begin dehumidifying.
b. If exhaust duct is attached, remove it from the rear of the air conditioner
c. Plug the Power Cord to the power outlet.
d. Turn on the unit by pressing the On/Off Button on the control panel.
e. Press the Mode Button until "DRY" appears on the LCD display.
NOTE: Do not use the exhaust duct when the unit is running at dehumidifying mode. You must
remove the exhaust duct from the unit. When the unit is running at dehumidifying mode, the fan
speed cannot be adjusted. Keep the windows and the doors closed to aid the efficiency of the unit
in removing the moisture from the room.
3. Fan Operation
a. Plug the Power Cord to the power outlet.
b. Turn on the unit by pressing the On/Off Button on the control panel.
c. Press the Mode Button until "COOL" appears on the LCD display.
d. Press the Temperature Button
the current room temperature. After two seconds the current room temperature
will appear on the LCD screen.
e. Set the fan speed to "LOW" "MEDIUM" or "HIGH" by pressing the Fan Speed
button.
4. Heating Operation
a. Plug the Power Cord to the power outlet.
b. Turn on the unit by pressing the On/Off Button on the control panel.
c. Press the Mode Button until "Heat" appears on the LCD display.
d. Press the Temperature Button
appears on the LCD. The temperature ranges from 63
NOTE: When the unit is operating in heating mode, the exhaust duct is not required.
or to set the temperature HIGHER than
or until the desired room temperature
10
o o o o
F-88 F (17 C-31 C).