SITRANS WS300 Speed Sensor
SITRANS WS300 speed sensor is a low- to high-resolution shaft driven speed sensor. It
measures the shaft's rotation by sending pulses to the integrator. The WS300 is certified
for use in hazardous and non-hazardous locations.
This small, light-weight speed sensor features:
•
Optional resolutions for accurate measurement over a range of belt speeds
•
Long bearing life
•
Corrosion resistance
Pulses are generated for each rotation of the WS300 shaft. These pulses are typically fed
into a Milltronics belt scale integrator. The integrator interprets the pulses and uses them
in the calculation of belt speed, flow rate, and material totalization.
The WS300 works with the following integrators:
•
Milltronics BW100
•
Milltronics BW500
•
SIWAREX FTC
•
Competitive integrators – consult your local Siemens representative
The WS300 sensors can also be used with older model Siemens integrators:
• Compuscale
• Compuscale II
For further information about Siemens products,
go to www.siemens.com/processautomation.
7ML19985ML01
SITRANS WS300 Speed Sensor – OPERATING INSTRUCTIONS
• Compuscale IIA
• Compuscale III
• Compu-M
Page 3