Connections; For Models Without A Sony Amplifier - Metra Electronics 99-5841B Installation Instructions Manual

Ford fusion2013-2017
Table of Contents

Advertisement

Attention! This interface will work with models that are either Sony amplified, or non-amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in
either no sound, or low sound. If you are unsure if your vehicle is factory amplified or not,
please contact your local dealership.
For models without a Sony amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• If the aftermarket radio has a mute wire, and the vehicle is equipped with SYNC
the Brown wire to it. If the mute wire is not connected, the radio will turn off when
®
SYNC
is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Tape off and disregard the following (5) wires, they will not be used in this application.
Blue/White, Green, Green/Black, Purple, Purple/Black
6

CONNECTIONS

The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
From the 5841 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
®
, connect
• Connect the Blue wire to the power antenna wire.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• For models with a 4.2-inch display screen and SYNC
jacks labeled "RSE/SYNC
• Disregard the Red and White RCA jacks labeled "FROM 3.5", they will not be
used in this application.
Continue to 3.5mm jack steering wheel control retention
®
: Connect the Red and White RCA
®
/SAT" to the audio AUX-IN jacks of the aftermarket radio.
1.800.221.0932
|
MetraOnline.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents