Starting The Engine - Snapper 555 Operator's Manual

STARTING THE ENGINE

1. Turn the fuel valve (B, Figure 5 & 6) to the ON posi-
tion.
2. Insert the engine key (F) into the engine key slot and
push fully in to the RUN position.
3. Move the throttle lever (E) fully up to the FAST posi-
tion.
4. Fully close the choke (G) if engine is cold. (Do not
choke a warm engine.)
5. Push the primerbutton (D) two times if engine is cold.
(Do not prime a warm engine.)
6. Pull starter handle (C) rapidly, or push starter button
if equipped with the electric start. Do not allow the
starter handle to snap back—let the starter rope
rewind slowly—while keeping a firm grip on the
starter handle.
7. As the engine starts and begins to operate evenly,
open the choke (G) slowly and set the throttle lever to
SLOW. If the engine falters, turn the choke knob
clockwise until the engine runs smoothly, and let it
run briefly before returning the choke to the OPEN
position.
NOTE: Allow the engine to warm up at SLOW throttle for
a few minutes before operating the snowthrower at full
speed. The engine will not develop full power until it
reaches operating temperature.
Tecumseh
B
Models
Figures 5. Engine Controls
A. Electric Start Button
B. Fuel Valve
C. Starter Handle
D. Primer Button
Briggs &
Stratton
Models
D
Figures 6. Engine Controls
A. Electric Start Button
B. Fuel Valve
C. Starter Handle
D. Primer Button
13
Operation
G
E. Throttle Lever
F. Engine Key
G. Choke Knob
G F B
E. Throttle Lever
F. Engine Key
G. Choke Knob
A
C
D
E
F
E
A
C