Recorder Section Adjustment; Recorder Setting For Destination; Y Level Adjustment - Canon ELURA10 A Service Manual

2-6 Recorder Section Adjustment

Preparation)
1) Except for the tape-path adjustment, carry out adjustment in the product state.

2-6-1 Recorder Setting for Destination

SPEC. Data writing
Procedure)
(1) Referring to the table shown below, carry out the recorder setting for destination market place.
ST EP PROCEDURE
RECORDER DEST INAT ION
1 1) Make the setting shown at right.
3) Press the ST ORE key.
2 1) Make the setting shown at right.
(For USA model)
2) Make the setting shown at right
(For Japan model)
3) Press the ST ORE key.

2-6-2 Y LEVEL Adjustment

TP/TRIG. VIDEO OUT
M. EQ. Oscilloscope
SPEC. Y=980 ± 20 [mV]
Procedure)
(1) Referring to the table shown below, carry out Y level adjustment.
ST EP PROCEDURE
Y LEVEL
1 1) Make the setting shown at right.
2) For adjustment, change data properly.
3) Press the ST ORE key.
CHAPTER 4. DISASSEMBLING ADJUSTMENT
MONIT OR
PG BK MD ADDR DT
6 5 WR **00 01
↑ ↑ ↑ ↑
RD
6 4 WR 0112 F0
6 4 WR 0112 F1
↑ ↑ ↑
RD F0orF1
980 ± 20mV
MONIT OR
PG BK MD ADDR DT
6 4 WR 001E ADJ
↑ ↑ ↑ ↑
"ADJ"
↑ ↑ ↑ ↑
RD
4-34
ELURA20 MC A, ELURA10 A
Microcomputer operation
ST
* High address "01" is set up.
Function Select bit for USA
Function Select bit for JPN
* T he recorder setting for destination
market place is completed.
Fig.4-24
Microcomputer operation
ST
White raster is output.
Adjustment is in progress.
* Adjustment is completed.