Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NDS ZeroWire Mobile
Summary of Contents for NDS ZeroWire Mobile
- Page 1 ZeroWire Mobile® USER MANUAL U.S. ONLY - ENGLISH...
- Page 3 Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. This document is subject to change without notice. NDS provides this information as reference only. Reference to products from other vendors does not imply any recommendation or endorsement.
-
Page 5: Table Of Contents
Lower the ZeroWire Mobile Center of Gravity ........ - Page 6 ZeroWire Mobile Assembly ........
-
Page 7: Safety Information
Safety Information Warnings and Cautions This symbol alerts the user that important information regarding the installation and/or operation of this equipment follows. Information preceded by this symbol should be read carefully in order to avoid damage to the equipment. This symbol warns the user that un-insulated voltage within the unit may have sufficient magnitude to cause electrical shock. -
Page 8: Warning Notices
Note: The Low Charge Level Alert is functionally critical and cannot be disabled. Warning: The ZeroWire Mobile should not be used with medical equipment that poses a safety risk to patients if battery power is lost, or the audible alert is not recognized. -
Page 9: Intended Use And Contraindications
Contraindications The ZeroWire Mobile is not intended for use with life supporting equipment, and under no circumstance must it be used in this way. Any use or integration with a medical device is strictly and exclusively the responsibility of the Medical Device manufacturer, agent, reseller or integrator selling this product. -
Page 10: General Specifications
General Specifications The ZeroWire Mobile is designed to provide power to an electrical load, and can be used continuously. ZeroWire Mobile The ZeroWire Mobile includes the following: • ZeroWire Mobile stand with 125 mm diameter casters (5x) • Rear-mounted fixed-position handle on the base column •... -
Page 11: Power Requirements
Use only NDS Power Modules. • To power off the ZeroWire Mobile stand, remove both Power Modules from the stand docks. • The ZeroWire Mobile stand must be positioned in a location with easy access to the stand docks. Power Module Requirements The capacity of a fully charged Power Module is 10 Ah. -
Page 12: Environmental Requirements
• Operating relative humidity range for the ZeroWire Mobile should not exceed 20% – 75% (non-condensing). • Operating altitude range for the ZeroWire Mobile should not exceed 0 – 6562 ft (0 – 2000 m), with a pressure range not to exceed 14.65 – 11.75 PSI (101 – 81 kPa). -
Page 13: Terms And Conditions
NDS neither assumes nor authorizes any person to assume for it any other liabilities in conjunction with and/or related to the sale and/or use of its products. To ensure proper use, handling and care of NDS products, customers should consult the product specific literature, instruction manual, and/or labeling included with the product or otherwise available. -
Page 14: Standard Warranty And Service
Subject to the conditions set forth below, NDS agrees to repair or replace any part of the enclosed unit for the length of period indicated on the chart below:... - Page 15 If the found failure type is covered under warranty, the repair, parts, labor and shipment back to the customer will be at no charge. b. If the found failure type is not covered under warranty, NDS’s then current evaluation fee will apply in addition to the cost of parts, labor and the return shipment.
- Page 16 NDS's liability is limited to the cost of repair or replacement of the product. NDS shall not be liable for: 1. Damage to other property caused by any defects in the product, damages based upon inconvenience, loss of use of the product, loss of time, loss of profits, loss of business opportunity, loss of goodwill, interference with business relationships, or other commercial loss, even if advised of the possibility of such damages.
-
Page 17: Zerowire Mobile Components
NDS 19”–26” monitors (Neutrik monitors (SwitchCraft connector) connector) 3. ZeroWire Mobile Wall Power Module Charger, 4-bay with one each 4. ZeroWire Mobile Power United States and European power cord Module (P/N 30D0001) ZeroWire Mobile Components | 11... -
Page 18: Zerowire Mobile Monitor Installation
1. Remove the monitor cable cover. 2. Connect the monitor DC power cable first to the ZeroWire Mobile DC output connector, and then to the monitor DC input connector, with the power cable passing between the release lever and monitor. -
Page 19: Zerowire Mobile Monitor Setup
ZeroWire Mobile Monitor Setup Height Adjustment of Monitor The ZeroWire Mobile supports approximate monitor heights as measured from the axis of the mounting plate hinge to the floor surface ranging from 55" – 69" (140 cm - 175 cm). To raise and lower the monitor... -
Page 20: Zerowire Mobile Transport
5. Firmly grasp the upper and lower handles and push the ZeroWire Mobile in the intended direction. Locked Unlocked Apply Caster Brake Locks 6. When the ZeroWire Mobile has been relocated, prevent accidental movement of the unit by applying the caster brake locks.. 14 | ZeroWire Mobile Transport... -
Page 21: Charging Station
3 hours to fully charge from a fully discharged state. After initial charging, charge levels of each Power Module are monitored, and charging is resumed if self-discharging drops a charge level below 95%. It is recommended that only fully charged Power Modules be installed for use on the ZeroWire Mobile. Charging Station Specifications... -
Page 22: Power Modules
When a ZeroWire Mobile with 2 modules installed is powered on, the Power Switch and Charge Level LEDs of the actively discharging Power Module are illuminated. The reserve Power Module displays only illuminated Charge Level LEDs. -
Page 23: Charge Level Led Indicators
Charge Level LED Indicators Each Charge Level LED represents approximately 10% of battery capacity. When all LEDs are illuminated, the Power Module is fully charged. Check Undocked Power Module Charge Levels Charge levels of undocked Power Modules can be checked by tapping the Power Switch to illuminate the Charge Level LEDs. -
Page 24: Power Module Docking
Slot Base The ZeroWire Mobile Stand automatically selects the active Power Module to supply power to the output. If a depleted Power Module is removed for charging and a Power Module with available capacity remains installed, the system will switch to the remaining Power Module with uninterrupted discharge. -
Page 25: Zerowire Mobile Assembly
ZeroWire Mobile Assembly Components of the ZeroWire Mobile stand included in your shipment: 1 Hinged Mounting Plate 2 Top Plate 3 Inner Extrusion Subassembly 4 Outer Extrusion Subassembly 5 M6x16mm Cap Head Screw (2x) 6 M6 Flat Washer (2x) IN G... -
Page 26: Field Replaceable Parts
Field Replaceable Parts Use only NDS approved Power Modules and replacement parts, certified for use with the ZeroWire Mobile system. Failure to comply will invalidate your warranty and may present serious dangers. For service, warranty replacement, or purchase of any items in the following list, contact NDS at: Americas: customercare@ndssi.com... -
Page 27: Charging Station Installation
Power Modules to and from the Charging Station and ZeroWire Mobile Stand(s). 2. Determine location of wall studs on which the Wall Mount Bracket will be attached, and determine an ergonomic height for the Charging Station installation. -
Page 28: Maintenance
• Before use, confirm that both Power Modules are fully charged and correctly docked. • Do not use or store any part of the ZeroWire Mobile system, including Power Modules and Charger in a loca- tion exposed to direct sunlight or sources of direct heat such as fire or a heater. - Page 29 Notes...
- Page 30 Notes...
-
Page 32: Contact
+81 3 5753 2466 info@ndssi.jp Oriental Media Center Suite 2302, Tower C No.4, Guang Hua Road Chao Yang District Beijing, 100026 China +86 10 8559 7859 info@ndssi.com.cn NDS Quality System ISO 9001:2008 and ISO 13485:2003 FDA Registration #2954921 60A0785 Rev A...