Inserting Cage Nuts Into The Rack Frame - Compaq ProLiant ML350 G2 Tower-To-Rack Conversion Manual

2-8 Compaq ProLiant ML350 Generation 2 Tower-to-Rack Conversion Guide

Inserting Cage Nuts into the Rack Frame

Use the fitting tool to insert cage nuts on the inside of the rails at the marked
locations. Make sure to install two cage nuts at the front of the rack and two
cage nuts at the back of the rack.
NOTE: The cage nuts and fitting tool are included in the hardware kit supplied with the
rack.
1. On the inside of the rail, hook one of the lips of the cage nut through the
square rail hole.
2. Insert the tip of the fitting tool through the other side of the hole, and
then hook the opposite lip of the cage nut.
Figure 2-2. Inserting cage nuts
3. Using the fitting tool as a lever, slide the cage nut lip into position.
4. Repeat this procedure for each cage nut.