Snapper EMRP216518B Safety Instructions & Operator's Manual page 10

Section 2 - OPERATING INSTRUCTIONS
2.8 INSTALLATION, COLLECTOR GRASS BAG
(Optional accessory on some models)
STEP 1: Install the grass bag adapter and secure to
the side and top of the deck with the two nuts
provided on the machine. Slot in front edge of
adapter must be under nut located on top of deck.
See Figure 2.9.
STEP 2: Install grass catcher by sliding connector
over flange of adapter. See Figure 2.11
ADAPTER
FLANGE
FIGURE 2.11
STEP 3: Grasp front and rear handles on bag and
begin bringing them together. Guide right and left
Bi-folds towards center of bag. See Figure 2.12
FIGURE 2.12
STEP 4: Guide connector plate on rear handle
into slot on front handle. See Figure 2.13.
STEP 5: Attach grass bag hooks over middle handle
cross bar. See Figure 2.14.
CONNECTOR
BRING HANDLES
TOGETHER. GUIDE
FOLDS TOWARDS
CENTER OF BAG
10
WARNING
DO NOT operate without entire Grass Catcher or
guard in place. Grass Catcher components are
subject to deterioration during normal use. Inspect
frequently and replace
components immediately.
FIGURE 2.13
FIGURE 2.14
worn or damaged
CONNECTOR