Cleaning And Maintenance; Ec Declaration Of Conformity - STEINEL XSolar L-S Instructions Manual

Risk of damage to property from penetrating
moisture
When open, the micro USB charging socket (E) is
not protected from the ingress of water.
• Only recharge batteries in a dry room.
• Connect micro USB charging adapter.
– Red LED fl ashes: charging in progress
The LED may take up to 10 minutes to start
fl ashing if the battery has run down to very
low level.
– Red LED shows: battery is fully charged.
• Remove micro USB charging adapter.
– Red LED goes out.
Risk of damage to property when light is not
in use
If the light is not used for a prolonged period
(e.g. in storage), the battery may suffer irreparable
damage from exhaustive discharge.
• Set programme selector switch to P0.
• The battery must be on full charge before taking
the light out of service.
• Regularly charge the battery while the light is
not in use.
7. Malfunctions
Red LED fl ashing in motion detector
– Battery capacity too low.
• Charge battery with micro USB charging
adapter (not included).
Light does not switch ON
– Battery capacity too low.
• Charge battery with micro USB charging
adapter (not included).
– Open or short circuit.
• Check connections.
– Programme selector switch set to P0.
• Set programme selector switch to P1 or P2.
– Detection zone not correctly adjusted.
• Check detection zone.
Light does not switch OFF
– Continued movement within the detection zone.
• Check detection zone.
Light switches ON when it should not
– Uncontrolled movement in the detection zone:
– Wind is moving trees and bushes.
– Cars in the street being detected.
– Sudden temperature changes due to weather
(wind, rain, snow) or air expelled from fans,
open windows.
• Check detection zone.
– Light is swaying (moving) due to gusts of wind or
heavy rain.
• Mount light on a fi rm surface.
Battery not charging
– Solar panel dirty.
• Clean solar panel with a soft cloth and mild
detergent.
– Solar panel not installed in the best place.
• Check site of installation (as much direct
sunlight as possible).
– It may no longer be possible to recharge the
battery after many years of use.
• Get rechargeable battery changed (replace-
ment XSolar battery, 3.3 V 2.5 AH, EAN
007841006488).
• Please send the product well-packed to your
nearest service station. The rechargeable
battery must only be replaced by the manu-
facturer or qualifi ed electricians.

8. Cleaning and Maintenance

The product requires no maintenance.
Regularly checking the product for damage can
prolong its lifespan.
Removing dirt can help to make the product work
longer.
Risk of damage to property
Using the wrong detergent can damage the light.
• Make sure detergent does not harm the surface.
• Clean light with a soft cloth and mild detergent.
If solar panel is dirty or weather has left deposits
on it:
• Clean solar panel with a soft cloth and mild
detergent.
– 12 – – 12 –
9. Disposal
• Observe any obligation in law to dispose of the
light in the proper manner.
• At the end of their useful life, channel lights and
rechargeable / normal batteries into the recycling
system in operation where you are (e.g. by
returning them to the point of sale or to a collec-
tion point that takes back harmful substances).
• At the end of their useful life, do not dispose of
lights and rechargeable / normal batteries
in unsorted household waste.
• Do not throw lights, rechargeable / normal
batteries into fi re or water at the end of their
useful life.
Ask your local authority for information.

10. EC Declaration of Conformity

This product complies with the requirements defi ned
in the following standards, legislation and directives:
– EMC Directive 2004/108/EC
– RoHS Directive 2011/65/EC
– Waste Electrical and Electronic Equipment Act
– Battery Act
– Directive on Waste Electrical and Electronic
Equipment WEEE 2012/19/EU
11. Guarantee
STEINEL product:
– Manufactured with the utmost care.
– Tested for proper operation and safety in
accordance with applicable regulations.
– With fi nal inspection.
STEINEL warranty:
– Warranty on perfect condition and proper
working order.
– 36 months starting on the day the product was
sold to the consumer.
– Covers the removal of defects resulting from
material fl aws or manufacturing faults.
– The warranty will be met by repair or replace-
ment of defective parts at our own discretion.
– The warranty does not cover damage to wearing
parts.
– This warranty does not cover damage and
defects resulting from improper treatment or
maintenance.
– Further consequential damage to other objects is
excluded from the warranty.
– Claims under the warranty will only be accepted
if the product is returned fully assembled with a
brief description of the fault, a receipt or invoice
(date of purchase and dealer's stamp).
• Please send the product well packed to the
appropriate Service Centre.
Repair service:
– Outside the warranty period.
– Defects not covered by the warranty.
• Ask your nearest service station for the
possibility of repair.
Further information:
http://www.steinel.de
– 13 – – 13 –