What To Do If - Electrolux 98030KF-SN User Manual

54

What to do if ...

What to do if ...
Problem
The cooking zones cannot be
switched on or are not operat-
ing
Acoustic signal sounds when
appliance is switched off
The residual heat indicator is
not displaying anything
Repeated acoustic signal (6x),
appliance switches off
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
Display is switching between
two heat settings
is lit
Possible cause
More than 10 seconds have
passed since the appliance was
switched on
The lock is switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch-off has been
triggered
There is water on the control
panel or the control panel is
covered with fat splashes
STOP+GO is activated
The control panel is wholly or
partly covered by objects.
The cooking zone was only on
for a short time and is therefore
not hot
One or more sensor fields have
been covered for longer than
10 seconds
The On/Off sensor field has
been covered up, e.g. by a cloth
Power management is reduc-
ing the power of this cooking
zone
Unsuitable cookware
No cookware on the cooking
zone
Diameter of the base of the
cookware is too small for the
cooking zone
Remedy
Switch the appliance on again.
Switch off the lock (See the
section "Locking/unlocking the
control panel")
Deactivate child safety device
(see the section "Child safety
device")
Only touch one sensor field
Remove any objects (pans, etc.)
that are lying on the control
panel. Switch appliance on
again
Wipe the control panel
Switch off STOP+GO
Remove objects.
If the cooking zone is supposed
to be hot, call your local Service
Force Centre.
Uncover sensor field
Do not place any objects on the
control panel
See the section "Switching the
power function on and off"
Use suitable cookware
Put cookware on zone
Move to smaller cooking zone
Use suitable cookware