Wheel Brake Adjustment; Mower Blade Replacement; Blade Wear Limits; Blade Sharpening - Snapper YZ145333BVE, YZ145383BVE Safety Instructions & Operator's Manual

Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance,
service or repairs with the engine running. Stop
engine. Stop blade. Engage parking brake. Remove
key. Remove spark plug wire from spark plug and
secure away from plug. Engine and components are
HOT. Avoid serious burns, allow all parts to cool
before working on machine. Fuel Filler Cap and Vent
must be closed securely to prevent fuel spillage.
Wear heavy leather gloves when handling or working
around cutting blades. Blades are extremely sharp and
can cause severe injury. DO NOT use a cutting blade
that shows signs of excessive wear or damage.

4.3.10. WHEEL BRAKE ADJUSTMENT

Adjust the wheel brake if wheels turn when parking
brake is engaged. Adjust the wheel brake by turning
wheel brake adjusting nut clockwise to increase
braking action or counter clockwise to decrease
braking action. See Figure 4.14.
ADJUST
COUNTER-
CLOCKWISE TO
DECREASE
BRAKE
ADJUST
CLOCKWISE
TO INCREASE
BRAKE
ELECTRIC
CLUTCH
WHEEL BRAKE
ROD
FIGURE 4.14

4.4 MOWER BLADE REPLACEMENT

4.4.1. BLADE WEAR LIMITS

1. Inspect blade frequently for signs of excessive wear
or damage. See Figure 4.15.
NEW BLADE
FIGURE 4.15
UNDERSIDE VIEW OF MACHINE
WEAR LIMIT
(NOTCH STARTS)
DANGEROUS CONDITION!
DO NOT USE ON MOWER!
REPLACE WITH NEW BLADE.

4.4.2. BLADE SHARPENING

1. Make sure fuel cap is on tight. Turn fuel shut off
valve (If equipped) to the "CLOSED" position. Start
engine and allow it to run until engine runs out of
fuel. Close vent on fuel filler cap. See Figure 2.3.
2. Remove key from ignition switch.
3. Remove spark plug wire(s) and secure away from
spark plug(s).
4. Carefully stand YARD CRUISER on rear bumper.
5. Remove blade(s). See Figure 4.16.
6. Inspect condition of blade. See Figure 4.14.
7. If blade is in good condition, sharpen at 22 to 28
degrees. DO NOT sharpen beyond existing cutting
edge. See Figure 4.17.
8. Check blade
necessary, correct blade balance by grinding the heavy
end of blade.
9. Reinstall blade. See Figure 4.16. Torque blade
mounting bolts to recommended range of:
33" Deck - 30 to 40 ft. lbs.
38" Deck - 80 to 90 ft. lbs.
33" DECK
DO NOT SHARPEN
BEYOND ORIGINAL
CUTTING EDGE
ORIGINAL CUTTING EDGE
20
balance after sharpening.
38" DECK
FIGURE 4.16
22º TO 28º
BLADE TIP
FIGURE 4.17
If