Rear Engine Rider Drive Components; Clutch - Starting Motion Adjustment; 4.3.2. Wheel Brake Adjustment - Snapper 421618BVE Safety Instructions & Operator's Manual

Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance,
service or repairs with the engine running. STOP
engine. STOP blade. Engage parking brake. Remove
key. Remove spark plug wire from spark plug and
secure away from plug. Engine and components are
HOT. Avoid serious burns, allow all parts to cool
before working on machine. Fuel Filler Cap and vent
must be closed securely to prevent fuel spillage.
4.3 REAR ENGINE RIDER DRIVE COMPONENTS
The following drive components may be adjusted by
the owner. However, it is recommended that all
adjustments to the Rear Engine Rider be made by
an authorized SNAPPER dealer.
4.3.1. CLUTCH - STARTING MOTION ADJUSTMENT
If the Rear Engine Rider clutch is too positive or
slips excessively when the clutch/brake pedal is
released, adjust as follows:
IMPORTANT: If the Rear Engine Rider will be on its rear
bumper for longer than two hours, remove the battery.
Refer to Section "BATTERY REMOVAL".
1. Follow WARNING statement found on this page.
2. Check fuel level in tank. If over 3/4 full, remove
tank. Refer to Section "REMOVING FUEL TANK". If
3/4 or less, proceed to next step.
3. Carefully stand Rear Engine Rider on rear bumper.
4. Locate yoke arm between chain case and
differential.
5. Move spring to first hole (for positive clutch
action) to 4th hole (to increase clutch slippage).
See Figure 4.7.
CLUTCH YOKE
ARM
LOCATE SPRING IN
I DESIRED HOLE
4.3.2. WHEEL BRAKE ADJUSTMENT
Test the wheel brake on a dry concrete surface. When
properly adjusted, the Rear Engine Rider will stop
within 5 feet from fastest speed. If stopping distance is
more than 5 feet, the wheel brake should be adjusted
as follows:
1. Follow WARNING statement found on this page.
2. Check fuel level in tank. If over 3/4 full, remove
tank. Refer to Section "REMOVING FUEL TANK". If
3/4 or less, proceed to next step.
3. Carefully stand Rear Engine Rider on rear bumper.
4. Depress clutch/brake pedal all the way down.
Move and hold the park brake lever in the "ON"
position and release the clutch/brake pedal to lock
the park brake. See Figure 4.8.
PUSH CLUTCH/BRAKE PEDAL
ALL THE WAY DOWN \
\
MOVE PARK
LEVER
TO "ON"
FIGURE 4.8
(Continued on next page)
FIGURE 4.7
20