Sd Card Removal - Dell S60 System Manual

Figure 7-1. The European WEEE symbo
l
In accordance with the European WEEE Directive, electrical and electronic equipment (EEE) is to be
collected separately and to be reused, recycled, or recovered at end of life. Users of EEE with the WEEE
marking per Annex IV of the WEEE Directive, as shown above, must not dispose of end of life EEE as
unsorted municipal waste, but use the collection framework available to customers for the return,
recycling and recovery of WEEE. Customer participation is important to minimize any potential effects
of EEE on the environment and human health due to the potential presence of hazardous substances in
EEE.
Dell Networking products, which fall within the scope of the WEEE, are labeled with the crossed-out
wheelie-bin symbol, as shown above, as required by WEEE.
For information on Dell Networking product recycling offerings, see the WEEE Recycling instructions
at: http://www.euro.dell.com/recycling.
For more information, contact the Dell Networking Technical Assistance Center (TAC) (see
the Technical Assistance

SD Card Removal

To support high-security environments, you can remove and re-install the SD card. Dell Networking
recommends only removing the card when necessary. Only authorized personnel should remove and
replace the card.
CAUTION: Only remove the SD card to support high-security operations and after discussions with Dell
Networking Technical Support or your Dell Networking representative.
To remove the SD card, follow these steps:
Step Task
Remove the small Phillips screws that connect the top to the body. There are three screws evenly spaced across
1
the rear and three screws evenly spaced along each side of the case.
Slide the top backwards until its front flange slides free of the faceplate. Lift it off.
2
Gently push the SD card to release it from the slot.
3
Center).
Contacting
S60 Specifications | 37