Table of Contents
Advertisement
Install the S60 System
To install the S60 system, Dell Force10 recommends completing the installation procedures in the order
presented in this chapter.
Always handle the S60 system and its components with care. Avoid dropping the system or its Field
Replaceable Units (FRUs).
This chapter describes the installation procedures as follows:
Install the S60 System in a Rack or Cabinet
1
Attach the Mounting Brackets
a
Install the Chassis into the Rack or Cabinet
b
Attach the Ground Cable
2
Insert Optional Modules
3
Connect Stacking Ports (Optional)
4
Supply Power and Power Up the System
5
WARNING: Electrostatic discharge (ESD) damage can occur if the components are mishandled. Always wear
an ESD-preventive wrist or heel ground strap when handling the S60 system and its components. As with all
electrical devices, take all the necessary safety precautions to prevent injury when installing this system.
Install the S60 System in a Rack or Cabinet
Attach the Mounting Brackets
The S60 system is shipped with mounting brackets (rack ears) and the required screws for rack or cabinet
installation. The brackets are enclosed in a package with the chassis.
NOTE: Dell Networking recommends attaching the brackets to the front of the chassis on the Power Supply
Unit (PSU) side. This provides the greatest weight support for the chassis in the rack or cabinet and is in
compliance with Bellcore Zone 4 earthquake requirements.
3
Install the S60 System
|
11
Advertisement
Table of Contents
