Deck Leveling Adjustment - Snapper SFH13320KW Safety Instructions & Operator's Manual

DECK LEVELING ADJUSTMENT

To Level the Mower Deck:
1. Park machine on a flat, level surface.
2. Raise the mower deck until it reaches the upper stop.
3A.If the mower deck is in the HIGH RANGE, place 2 x
4 blocks under the outside edges of the mower deck
with the 3-1/2" sides being vertical. Place a 1/8"
(3mm) thick spacer on top of the rear 2 x 4 blocks.
(See Figure 13)
3B.If the mower deck is in the LOW RANGE, place 2 x 4
blocks under the outside edges of the mower deck
with the 1-1/2" sides being vertical. Place a 1/8"
(3mm) thick spacer on top of the rear 2 x 4 blocks.
(See Figure 13)
4. Lower the mower deck until the deck rests against
the 2 x 4 blocks and spacers.
5. Loosen the bolts (A, Figure 14) that secure the con-
necting links (B) together. This will remove any ten-
sion from the mounting linkages and pivots.
6. Retighten the bolts securely.
7. Verify that the deck height indicator (C) is aligned
with the 4" mark (if in the HIGH RANGE) or the 2"
mark (if in the LOW RANGE). Adjust the indicator
position if necessary.
8. Remove the blocks from under the mower deck.
00
Troubleshooting, Adjustment & Service
Figure 13. 2 x 4 Placement
B
Figure 14. Deck Leveling Linkages
A. Linkage Bolts
B. Connecting Links
C. Deck Height Indicator
D. 2 x 4 Blocks
19
C
B
A
A
D