Omron E5CC Solution Manual page 6

Using ON/OFF Control
Step 2 Setting ON/OFF Control Parameters
Setting ON/OFF Control
1
You set this parameter in the Initial Setting Level. The parameter is set to ON/OFF control by default.
1
Turn ON the power supply.
2
Press the K ey for at least 3 seconds.
Press the
(Level) Key for
at least 3
seconds.
3
Change the parameter with the
Press the
several times to display
cntl(CNTL).
Setting Direct or Reverse Operation
2
You set this parameter in the Initial Setting Level. The parameter is set to reverse operation by
default.
1
Change the parameter with the
Press the
several times to display
orev (OREV).
Change the set value with the
(When finished, press the
to the operation display.)
Simplicity on the Worksite
2-2
Operating Display
←Flashes 3 times.
Key .
Initial Setting Level
( Mode) Key
Ke y.
Initial Setting Level
( Mode) Key
(Up and Down) Keys.
(Level) Key for at least 1 second to return
Initial Setting Level
←in-t (IN-T) will be displayed to
show that the Initial Setting Level
has been entered.
←cntl(CNTL): Indicates the Control Method
parameter.
←Default setting is onof (ONOF): ON/OFF
control.
If pid (PID control) is displayed, press
the ( Down) Key to change to onof
(ONOF) (ON/OFF control).
←orev (OREV): Indicates the
Direct/Reverse Operation parameter.
←Default setting is or-r (OR-R):
Reverse operation.
or-r (OR-R): Reverse operation (default)
or-d (OR-D): Direct operation
Solutions Guide for FAQs: E5CC/E5EC