Configure Ma Output Fault Action And Ma Output Fault Level - Emerson Micro Motion 2500 Configuration And Use Manual

Integrate the meter with the control system
Table 6-7: Valid values for Added Damping
Setting of Update Rate
Special
Interaction between mA Output Damping and process
variable damping
When mA Output Source is set to a flow rate variable, density, or temperature, mA Output
Damping interacts with Flow Damping, Density Damping, or Temperature Damping. If
multiple damping parameters are applicable, the effect of damping the process variable is
calculated first, and the mA Output damping calculation is applied to the result of that
calculation.
Example: Damping interaction
Configuration:
•
•
•
Result: A change in the mass flow rate will be reflected in the mA Output over a time
period that is greater than 3 seconds. The exact time period is calculated by the
transmitter according to internal algorithms which are not configurable.
6.2.5 Configure mA Output Fault Action and mA Output Fault
Level
ProLink III
Field Communicator
Overview
mA Output Fault Action controls the behavior of the mA Output if the transmitter
encounters an internal fault condition.
84
(continued)
Process variable
100 Hz variable (if assigned
to the mA Output)
100 Hz variable (if not as-
signed to the mA Output)
All other process variables
Flow Damping = 1 second
mA Output Source = Mass Flow Rate
mA Output Damping = 2 seconds
Device Tools > Configuration > Fault Processing
• Configure > Manual Setup > Inputs/Outputs > mA Output 1 > MA01 Fault Settings
• Configure > Manual Setup > Inputs/Outputs > mA Output 2 > MA02 Fault Settings
Micro Motion Model 2500 Transmitters with Configurable Input/Outputs
Update rate
in effect Valid values for Added Damping
100 Hz
0.0, 0.04, 0.12, 0.30, 0.64, 1.32, 2.6, 5.4, 11, 22,
44, 88, 176, 350
6.25 Hz
0.0, 0.32, 0.96, 2.40, 5.12, 10.56, 20.8, 43.2, 88,
176, 352