Steering Tie Rod; Blade Engagement Mechanism; Park Brake Lever; Deck Lift Mechanism - Snapper LT145H33HBV, LT145H38HBV, LT150H38HKV, WLT145H38HBV Safety Instructions & Operator's Manual

Section 3 - MAINTENANCE
3.3.4. TRACTOR LUBRICATION
(Continued From Previous Page)

7. Steering Tie Rod

Lubricate both ends of steering tie rod with a small
amount of SAE30 oil. See Figure 3.10.
FIGURE 3.10

8. Blade Engagement Mechanism

Using SAE30 oil, lubricate the blade engagement
mechanism pivot points, which are located on the
R.H. underside of tractor. See Figure 3.11.
FIGURE 3.11

9. Park Brake Lever

Using general purpose grease, lubricate the park
brake lever mechanism pivot points, which are
located on the left hand underside of tractor. See
Figure 3.12. mechanism with a thin coat of 30 wt.
motor oil.
LUBRICATE
BOTH ENDS
OF TIE ROD
LUBRICATE
COMPONENTS ON
UNDERSIDE OF
TRACTOR
BLADE
ENGAGEMENT
LEVER
15
LUBRICATE COMPONENTS
ON UNDERSIDE OF TRACTOR
FIGURE 3.12
10.

Deck Lift Mechanism

Lubricate all wear and pivot points of the deck lift

3.4 SERVICE - ANNUALLY

Perform all maintenance as described in Section
"SERVICE - EVERY 25 OPERATING HOURS". Also
see service schedule.
3.4.1.

ENGINE

1. Service engine according to engine owner's
manual.
3.4.2.

FUEL FILTER

1. Service fuel filter as instructed below, on COLD
ENGINE ONLY!
NOTE: It may be necessary to drain the fuel tank before
removing fuel filter to prevent spillage of gasoline.
2. Locate fuel filter. Remove hose clamps and fuel
hoses from both sides of fuel filter. See Figure 3.13.
REMOVE
HOSE CLAMPS
FIGURE 3.13
PARK BRAKE
LEVER
FUEL TANK
FUEL FILTER