Service – Every 25 Operating Hours; Steering Drag Link; Steering Tie Rod; Park Brake Lever - Snapper LT180H42IBV, LT200H42IBV2, LT200H48IBV2 Safety Instructions & Operator's Manual

Section 3 - MAINTENANCE
3.3.5. TRACTOR LUBRICATION

6. Steering Drag Link

Lubricate both ends of steering drag link with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.10.
FIGURE 3.10

7. Steering Tie Rod

Lubricate both ends of steering tie rod with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.11.
FIGURE 3.11

8. Park Brake Lever

Using 30 wt. motor oil, lubricate the park brake lever
mechanism pivot points, which are located on the left
hand underside of tractor. See Figure 3.12. Lubricate
mechanism with a thin coat of 30 wt. motor oil.
LUBRICATE
COMPONENTS ON
UNDERSIDE OF
TRACTOR
FIGURE 3.12
DRAG LINK
LUBRICATION
POINT
LUBRICATE
BOTH ENDS
OF TIE ROD
PARK BRAKE
LEVER
17

9. Deck Lift Mechanism

Lubricate all wear and pivot points of the deck lift.
3.4 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in Section
"SERVICE - EVERY 25 OPERATING HOURS". Also
see Service Schedule.
3.4.1.

ENGINE

1. Service engine according to engine owner's
manual.
3.4.2.

FUEL FILTER

1. Service fuel filter as instructed below, on COLD
ENGINE ONLY!
NOTE: It may be necessary to drain the fuel tank before
removing fuel filter to prevent spillage of gasoline.
2. Locate fuel filter. Remove hose clamps and fuel
hoses from both sides of fuel filter.
3. Install new fuel filter part number 1-4359. See
Figure 3.13.
NEW FUEL FILTER
PART NUMBER 1-4359
FIGURE 3.13
4. Fill fuel tank with fresh gasoline. Refer to engine
owner's manual for fuel specifications.
3.4.3.

SPARK PLUG

Remove and replace engine spark plug. Refer to
engine owner's manual for correct replacement plug
and gap specifications.
3.4.4.

HYDROSTATIC TRANSMISSION OIL

The hydrostatic transmission does not require
maintenance. If
immediately to a Snapper dealer.
any problems arise return