Parking Brake; Cutting Height Adjustment - Snapper LT145H33HBV, LT145H38HBV, LT150H38HKV, WLT145H38HBV Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS
2.4 STOPPING
2.4.3. STOPPING MOWER BLADE
1. Stop mower blade by moving blade engagement
lever down to the "OFF" position. See Figure 2.11.
FIGURE 2.11
WARNING
Once blade is disengaged, it should come to a
complete stop in 5 seconds or less.
continues to rotate after 5 seconds, the blade brake
must be adjusted. Refer to Section "BLADE BRAKE
ADJUSTMENT" for adjustment procedures or return
machine to dealer for adjustment. DO NOT CONTINUE
to operate mower until blade brake is properly adjusted.
2.4.4. SETTING PARK BRAKE
1. Fully depress clutch/brake pedal.
2. Move park brake lever up into slot. See Figure 2.12.
PUSH PEDAL ALL
THE WAY DOWN
MOVE PARK BRAKE
LEVER "UP" TO
ENGAGE PARK BRAKE
FIGURE 2.12
BLADE
ENGAGEMENT
LEVER
OFF
If the blade
PARK BRAKE
LEVER
2.4.5. RELEASING PARK BRAKE
1. Fully depress clutch/brake pedal. Move park brake
lever "DOWN" to release park brake. Release
clutch/brake pedal. See Figure 2.13.
CLUTCH/BRAKE
PEDAL

2.5. CUTTING HEIGHT ADJUSTMENT

1. Depress lock button on cutting height adjustment
lever. See Figure 2.14.
DEPRESS
LOCK BUTTON
HIGHEST CUT
2. Raise or lower deck to any of six positions as
desired. Release lock button.
WARNING
DO NOT park machine on slopes.
9
PARK BRAKE
LEVER
FULLY DEPRESS
CLUTCH/BRAKE
PEDAL
FIGURE 2.13
CUTTING
HEIGHT
ADJUSTMENT
LEVER
LOWEST CUT
FIGURE 2.14