Table of Contents
Advertisement
Troubleshooting
and FAQs
This chapter describes some common problems that may be encountered when
using the
Adapter, and ways to resolve the problems. Also included is a list of
USB
frequently asked questions.
Troubleshooting
The Adapter can't connect to an access point.
From the Network Properties applet, perform the following steps:
• Make sure the operating mode is set to Infrastructure mode.
• Make sure that the
access points are case sensitive and require all devices to match the letter
case as well.
• Check the security settings. In the
make sure all of the
point.
Changing the Adapter's IP address.
There are two methods to change the Adapter's
• Open the
USB
applet. Click on the
ton, and change the
• If you still have problems, unplug the Adapter from the computer and plug
it back in. Then, change the
is the same as the
SSID
settings match the
WEP
Adapter Network Connection from the Network Properties
Settings screen, click the Static
IP
address.
IP
address again.
IP
of the access point. Many
SSID
Encryption window, for example,
WEP
settings of the access
WEP
address:
IP
17
5
Address radio but-
IP
Advertisement
Table of Contents
