Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ActionTec 802CAG
Summary of Contents for ActionTec 802CAG
- Page 1 Actiontec 802.11a/g Dual Band CardBus Adapter 802CAG User Manual Page: 1...
- Page 2 1. Content 1. Contents 2. Introduction 3. Installation Overview 4. Regulatory Compliance Information Page: 2...
-
Page 3: Device Description
2. Instruction Device Description The 802CAG is the Wireless cardbus adapter to support IEEE 802.11a, 802.11b & 802.11g standard. The design is based on Atheros AR5001X+ Combo WLAN chip set: AR5111 5GHz radio, AR2111 2.4GHz radio, and AR5212 802.11a/b/g MAC + Baseband. -
Page 4: Installation Overview
3. Installation Overview Actiontec recommends that you remove any existing Atheros drivers on the PC system before installing Version 1.0 release of the NDIS driver. With on existing Actiontec NDIS driver installed, insert the Actiontec Wireless Network Adapter into a 32-bit CardBus slot, and follow these steps to install the NDIS driver: 1. -
Page 5: Infrastructure Mode
Infrastructure Mode To set up automatic wireless network configuration to connect to an existing Access Point (infrastructure network), follow these steps: 1. Click the network name under “Available networks” in the Wireless Networks tab, and click Configure. You can update the list of available networks that are within range of your computer by clicking Refresh under Available Networks. - Page 6 Connect to an Available Wireless Network When there is more than one available network detected by Windows XP, the OS will prompt you to select and connect to a preferred network. To connect to an available wireless network, right-click the network connection icon in the notification area, and then click “View Available Wireless Networks”.
-
Page 7: Regulatory Compliance Information
We, Actiontec Electronics, Inc. 760 North Mary Ave., Sunnyvale, CA 94086 USA declare under our sole responsibility that the product 802CAG – 802.11a/b/g Dual Band CardBus Adapter complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that my cause undesired operation. - Page 8 Modifications made to the product, unless expressly approved by Actiontec Electronics, Inc. could void the user’s authority to operate the equipment. RF Exposure This device has been tested for compliance with FCC RF Exposure (SAR) limited in typical laptop configurations.
- Page 9 60, 64, 100, 104, 108, 112, 116, Sweden 120, 124, 128, 132, 136, 140) 2446.5Mhz - 2483.5Mhz France (Channels 10,11,12,13) For questions regarding your product, please contact: Actiontec Electronics, Inc 760 North Mary Ave, Sunnyvale, CA 94086 United States Phone 408-752-7700 408-732-0087 Email www.actiontec.com...