Nokia N71 User Manual page 86

R1114_en.book Page 86 Tuesday, January 24, 2006 2:04 PM
service, you will not be able to make calls. When line 2 is
selected, is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change—To prevent line selection (network service),
select Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.
Connection settings
Tip! Some of your device settings can be
automatically set up using the Settings Wizard, see
'Settings Wizard' p. 82.
Data connections and access points
Your device supports packet data connections, such as
GPRS in the GSM network. When you use your device in
GSM network, multiple data connections can be active at
the same time, and access points can share a data
connection.
To establish a data connection, an access point is required.
You can define different kinds of access points:
86
• MMS access point to send and receive multimedia
messages
• Access point for the Services application to view WML
or XHTML pages
• Internet access point (IAP) to send and receive e-mail
and connect to the Internet
Check the type of access point you need with your service
provider for the service you want to access. For availability
and subscription to packet data connection services,
contact your network operator or service provider.
Access points
You may receive access point settings in a message from a
service provider. See 'Data and settings', p. 40. Some or all
access points may be preset for your device by your service
provider or network operator, and you may not be able to
change, create, edit, or remove them.
protected access point.
indicates a packet data access point.
To create a new access point, select Options
point. To edit the settings of an access point, select
Options > Edit. Follow the instructions from your service
provider.
Connection name—Enter a descriptive name for the
connection.
Data bearer—Select the data connection type.
indicates a
> New access