Nokia N71 User Manual page 104

Complete_Safety.fm Page 104 Tuesday, May 23, 2006 11:51 AM
To make an emergency call:
1
If the device is not on, switch it on. Check for adequate
signal strength.
Some networks may require that a valid SIM card is
properly inserted in the device.
2
Press as many times as needed to clear the display
and ready the device for calls.
3
Enter the official emergency number for your present
location. Emergency numbers vary by location.
4
Press the key.
If certain features are in use, you may first need to turn those
features off before you can make an emergency call. Consult
this guide or your service provider for more information.
When making an emergency call, give all the necessary
information as accurately as possible. Your wireless device
may be the only means of communication at the scene of an
accident. Do not end the call until given permission to do so.
Certification information (SAR)
THIS DEVICE MEETS THE GOVERNMENT'S REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
Your mobile device is a radio transmitter and receiver. It is
designed and manufactured not to exceed the limits for
exposure to radio frequency (RF) energy adopted by the
governments of the USA through the Federal
Communications Commission (FCC) and Canada through
Industry Canada (IC). These limits establish permitted levels of
RF energy for the general population. The guidelines are based
104
on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety
margin designed to assure the safety of all persons, regardless
of age and health.
The exposure guidelines for mobile devices employ a unit of
measurement known as the Specific Absorption Rate or SAR.
The SAR limit adopted by the USA and Canada is 1.6 watts/
kilogram (W/kg) averaged over one gram of tissue. The limit
incorporates a substantial margin of safety to give additional
protection for the public and to account for any variations in
measurements. Tests for SAR are conducted using standard
operating positions with the device transmitting at its highest
certified power level in all tested frequency bands. The actual
SAR level of an operating device can be well below the
maximum value because the device is designed to use only the
power required to reach the network. That amount changes
depending on a number of factors such as how close you are
to a network base station.
The highest SAR value reported to the FCC and IC for this
device type when tested for use at the ear is 0.41W/kg, and
when properly worn on the body is 0.24W/kg. SAR information
on file with the FCC can be found under the Display Grant
section of http://www.fcc.gov/oet/fccid after searching on FCC
ID OW3RM-112. SAR values reported in other countries may
vary depending on differences in reporting and testing
requirements and the network band. Additional SAR
information may be provided under product information at
http://www.nokia.com.