Smart Technology X-Pert Control; Steam Boost Function; Maintenance And Cleaning - TEFAL Pro Express Care Manual

Smart Technology X-Pert control

During use if you have not used the steam function for a few minutes, press the steam control button several
times in a row. Holding the iron away from your laundry. This will remove the cold water from the steam
circuit.
Your iron is equipped with the electronic regulation SMART TECHNOLOGY X-PERT CONTROL which offers fi ve optimal
temperature and steam fl ow combinations.
SYNTH.
(Polyester, Acetate, Acrylic,
Nylon)
SILK
WOOL
COTTON
LINEN
Warning, fabrics with the symbol
Start with the fabrics to be ironed at a low temperature and fi nish with those that need higher temperature. When you
select a higher temperature, you can continue to iron. If you select a lower temperature you should wait until the lights
stop fl ashing before you continue to iron (to allow enough time for the soleplate to cool down). If you are in doubt
about the type of fabric an item of clothing is made from, check the label.
If you are ironing woollen garments, press repeatedly on the steam control button without placing the
iron on the garment. This will avoid it becoming shiny. The «ECO» function allows you to reduce energy
consumption for the selected mode. To change to «ECO» mode, select either the SYNTH. / SILK / WOOL
/ COTTON / LINEN mode and press on the «ECO»button. The «ECO» button will light up. To exit «ECO»
mode, press the «ECO» button again and the light will go off.
Dry ironing
• Do not press the steam control button under the iron handle.

Steam Boost Function

• Your appliance includes the Steam boost: automatic sequential steam for effortless use. To be used in particular for
thick fabrics.
• To obtain this function, press the steam control button under the handle three times in quick succession.
Refi lling the tank during use
• When the red «Tank empty» light is fl ashing, there is no more steam. The water tank is empty.
1.Close the protection cover* until you hear a «click».
2. Remove the detachable water tank using the handle (located at the front of the steam generator) and fi ll it without
exceeding the MAX level.
3. Push it back into its housing until you hear a «click».
4. Press the «OK» restart button under the control panel to continue ironing.
5. Open the protection cover* . When the «ON-OFF» button light remains on, the steam is ready.

Maintenance and cleaning

Before cleaning, ensure your steam generator is unplugged and that the soleplate and the iron have cooled
down.
are not suitable for ironing.