Drying Rack - Electrolux TK L2 E User Manual

Condenser dryer with drying rack
Hide thumbs Also See for TK L2 E:
Table of Contents

Advertisement

Available languages

Available languages

66 electrolux
• prevents children from playing with the control
parts of the appliance
• do not let accidentally stop or change an active
programme
• deactivates all push buttons and the programme
dial
To set/cancel the child lock :
1. Push and hold the Buzzer (Signal) and the Time
(Zeitwahl) buttons simultaneously for 5 sec-
onds.
2. Release both push buttons when the symbol:
is on/off in the display.
To change or set a new programme, you
must deactivate the child lock function.
Starting the programme
Push the Start / Pause button. The approximate
cycle time visible on the display starts to elapse.
Changing programme
To change a programme which has been selected
by mistake once the programme has started, first
turn the programme selector to OFF and then reset
the programme.
The programme can no longer be changed
directly once the programme has started. If
nevertheless there is an attempt to change the
programme on the programme knob, the pro-
gramme progress display and the maintenance in-
dicators flash. If an option (excluding the buzzer )
is set, Err appears in the multidisplay. The drying

Drying rack

Special equipment for gentle drying washable
woollens and sport shoes. Incomparable for drying
wet woollens - eliminated movement, protection
from matting.
For drying rack unpacking see Installation
chapter.
Important! Before drying rack installation check
the dryer drum. It must be empty!
Sport shoes cannot be dry without the drying rack
- drum damage.
Installation and use
1. Open the loading door.
2. Insert the rack carefully resting its two support
brackets on the front of plastic flange.
programme is not however affected by this (laun-
dry protection).
Cycle end / laundry unloading
Important! After each drying cycle:
• clean the fluff filters
• drain the condensed water container
(see " Care and cleaning " chapter.)
Once the drying cycle is complete, display shows
a blinking
. If the Buzzer (Signal) button has been
pressed, an acoustic signal sounds intermittently
for about one minute.
The drying cycles are automatically followed
by an anti-crease phase which lasts around
30 minutes. The drum rotates at intervals during
this phase. This keeps the laundry loose and free
of creases. The laundry can be removed at any
time during the anti-crease phase. (The laundry
should be taken out towards the end of the anti-
crease phase at the latest to prevent creases from
forming.) If long anti-crease function has been se-
lected, the anti-crease phase is lengthened by 60
minutes.
1. Open door.
2. Remove fluff from the fluff filters (see " Care and
cleaning " chapter.)
3. Remove laundry.
4. Turn the programme selector to OFFposition.
5. Close the door.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents