Section 2 - OPERATING INSTRUCTIONS
2.4 STOPPING - ENGINE, WHEEL DRIVE, BLADE
2.4.4. PARK BRAKE
1. Engage park brake by pushing clutch/brake pedal
"DOWN" and moving the park brake lever to the "ON"
position. While holding the park brake lever "ON",
release clutch/brake pedal to set park brake.
See Figure 2.16.
PUSH CLUTCH/BRAKE
PEDAL ALL THE WAY
DOWN
FIGURE 2.16
2. Release park brake by pushing down on the
clutch/brake pedal to release park brake lever. See
Figure 2.17.
PUSH CLUTCH/BRAKE
PEDAL ALL THE WAY
DOWN
FIGURE 2.17
2.5. CUTTING HEIGHT ADJUSTMENT
MOVE PARK
BRAKE LEVER
TO "ON"
11
1. Adjust cutting height as desired to any one of six
positions using deck lift lever. When in desired
height of cut, release latch, then try to move deck
lift lever to ensure lift lever latch is fully engaged.
See Figure 2.18.
LIFT LEVER
LATCH
FIGURE 2.18
WARNING
DO NOT park machine on slopes.
DECK LIFT
LEVER