How To Delete A Channel; How To Turn Channel Scan On / Off - Ritron PATRIOT PBS-446D Operating Manual

PROGRAMMING THE RADIO

How to Delete a Channel

In our example we will delete channel 3.
1. Follow the instructions in FIG-4 on
page 12 to place the radio in the
Program/ Readout Mode. A "P" will
appear on the channel display as you
enter program mode.
2. Press the Channel Selector button to
select the channel to be deleted. The
C
channel number will show briefly on
H
the channel display as you step
A
through the channels.
N
N
E
3. When you have settled on a channel
L
the display will show a hyphen across
the center to indicate that it is ready
for deleting.
4. Enter the 1
"0000" by clicking the PTT button until
the channel display shows "0".
5. Pause—the radio will sound a low
tone and show a hyphen across the
center of the display to indicate that it
is ready to accept the next digit.
6. Enter the 2
"0000" by clicking the PTT button until
the channel display shows "0".
D
E
7. Pause—the radio will sound a low
L
tone and show a hyphen across the
E
center of the display to indicate that it
T
is ready to accept the next digit.
E
8. Enter the 3
C
"0000" by clicking the PTT button until
O
the channel display shows "0".
D
E
9. Pause—the radio will sound a low
tone and show a hyphen across the
center of the display to indicate that it
is ready to accept the next digit.
10.Enter the 4
"0000" by clicking the PTT button until
the channel display shows "0".
11.Pause—the radio will sound a low
tone and show a hyphen across the
center of the display to indicate that it
is ready to accept the next digit.
12.Press and release the On/ Volume Up
to save your delete programming.
The radio display will briefly show the
channel number, then a triple beep
will sound to indicate that the channel
was successfully deleted.
13.To delete another channel, repeat
steps 2 through 12.
st
digit of delete code
nd
digit of delete code
rd
digit of delete code
th
digit of delete code
14. Turn the radio and then
OFF
is now ready to use.
15. The remaining channels are in the same
sequence and will retain their same channel
number. The Channel Selector will skip over the
deleted channel numbers.
NOTE: If all channels are deleted the radio will not
operate, instead it will turn on in Field Program mode
to allow entry of a valid frequency and tone code.

How to Turn Channel Scan On / Off

1. Follow the instructions in FIG-4 on
page 12 to place the radio in the
Program/ Readout Mode. A "P" will
appear on the channel display as you
enter program mode.
2. Enter code "1" to turn channel scan
on. Enter the code by clicking the
PTT button until the channel display
shows "1".
S
C
3. Pause—the radio will sound a low
A
tone and show a hyphen across the
N
center of the display.
O
4. Press and release the On/ Volume Up
N
to save your programming. The radio
will sound a triple beep to confirm that
channel scan has been turned on.
5. Enter code "2" to turn channel scan
off. Enter the code by clicking the
PTT button until the channel display
shows "2".
S
C
A
6. Pause—the radio will sound a low
N
tone and show a hyphen across the
center of the display.
O
F
7. Press and release the On/ Volume Up
F
to save your programming. The radio
will sound a triple beep to confirm that
channel scan has been turned off.
8. Turn the radio
again—the radio is now ready to use.
PBS-446D
again—the radio
ON
and then
OFF ON
12