Table of Contents
Advertisement
QUICK START GUIDE
FACTORY INSTALLED DRAIN PUMP
If your drain line will run up to a stand pipe, disposal or
spigot assembly, or does not otherwise meet the
requirements for a gravity drain, you may have ordered a
pre-installed U-Line P60 drain pump.
If you need to install a P60 drain pump into your unit, see
DRAIN PUMP section in the User Manual.
See below for typical installations requiring a drain pump.
Stand Pipe
P60 Pump Required
Disposal Assembly
P60 Pump Required
Air Gap
(Optional Hook-Up)
Waste
Valve
Cold
Hot
Water
Water
Waste
Waste
Cold
Water
Hot
Water
Valve
Y-Branch Tailpiece
P60 Pump Required
(Optional Hook-Up)
The maximum lift for the P60 drain pump is
10 feet. This must be done as close to the rear of
the unit as possible.
Door Swing
Door Swing
Units have a zero clearance for the door to open 90°,
when installed adjacent to cabinets.
Stainless Steel models require 2-1/8" (54 mm) door
clearance to accommodate the handle if installed next to a
wall.
10
Air Gap
Valve
Hot
Water
Wall
2-1/8" Min.
(54 mm)
90°
u-line.com
Waste
Cold
Water
Advertisement
Table of Contents
