Servicing The Mower Blades - Snapper 19HP User Manual

Regular Maintenance
WARNING
For your personal safety, do not handle the sharp
mower blades with bare hands. Careless or
improper handling of blades may result in serious
injury.
WARNING
For your personal safety, blade mounting
capscrews must each be installed with a hex/spline
washer and spring washer, then securely tightened.
Torque blade mounting capscrew to 45-55 ft. lbs.
(61-75 N.m.)

SERVICING THE MOWER BLADES

Service Interval: Every 10 Hours or As Required
1. Remove mower deck (see "Mower Deck Removal").
2. See Figure 14. To remove blade for sharpening, use
a block of wood to prevent blade rotation while
loosening the capscrew.
3. Remove the capscrew (D, Figure 16), spring washer
(C), hex washer (B), and blade.
4. Use a file to sharpen blade to a fine edge. If blade is
damaged, it must be replaced.
5. Balance the blade as shown in Figure 15. Center the
blade's hole on a nail lubricated with a drop of oil. A
balanced blade will remain level.
6. Reinstall the blade (Figure 16) with the tabs pointing
up toward the mower deck as shown.
7. Reinstall the hex washer (B, Figure 16), spring
washer (C) and capscrew (D). Use a wooden block
(A) to prevent blade rotation while tightening the
capscrew (D) to 45-55 ft. lbs. (61-75 N.m).
Figure 14. Blade Removal
Workbench
Figure 15. Balancing The Blade
A
Figure 16. Blade Installation
A. 4x4 Wood Block
B. Hex Washer
C. Spring Washer
D. Blade Capscrew
18
Nail
B
C
D