Advertisement
F i g u r e 6 . T r a c t o r D a s h
A . W o o d B l o c k : 6. H a m m e r C . S c r e w s
hammer and block of wood as shown in figure 6.
Loosen capscrew and washer that secures throttle
be reinstalled in same position for correct RPM
settings. Remove cable from engine.
19. Remove nut (A, figure 7). flatwashers (B) and
steering wheel off shaft.
Figure 7. Steering Wheel
A, 5/16 Locknut
C. 5116 x 3-l/2 Capscrew
D. Steering Wheel
E. Cap
20. Remove the upper and lower dash hardware as
follows.
a. Remove the two screws (C, figure 6) and washers.
b. Raise the hood and loosen the two screws, plain
washers, dished washers and nuts from front side
of dash (see figure 8).
c. Remove four capscrews
lower dash.
d. Both dashboards can now be lifted up for access to
wiring.
21. Remove the ignition switch by removing nut. Retain
lockwasher for reinstallation.
22. Reach thru the hole in top of lower dash and install
the switch (A, figure I). Position the switch so that
slot in threads is up. From outside the dash, place the
washers (B) on switch, aligning tab washer in slot in
threads. Install and tighten the nut securely.
23. Connect black switch wire to white wire from
ignition switch with connector (C, figure 1) provided
in kit.
1) from switch and ground under this screw.
25. Route the yellow and red wires from switch down
behind the steering shaft. Wires should follow wiring '---
harness and be routed cut lower dash cutout,
underneath shift quadrant panel and thru square,
hole for seat latch. Refer to figure 5. Wires should
then
attached to wire clip (D, figure 5).
be
26. Connect the yellow wire to yellow wire from cylinder.
Connect the red wire to the red wire from cylinder.
27. This completes installation of the kit. Make the :
following test to see if installation is correct.
a. Reinstall ignition switch with lockwasherand
b. Connect the
battery
d. Flip the lift switch up, the lift arm should go back.
forward.
f. If switch does not check OK, disconnect the
battery cables, Then go thru the instructions and ~
make sure all connections are tight.
g. Reconnect the battery cables to perform above
test again. Before proceeding with following :
instructions, disconnect the battery cables.
28. Reinstall lower dash with four capscrews and
washers. Position the upper dash over the fuel tank.
Install the original hardware (figure 8).
and washers securing
nut.
cables - negative cable last.
Advertisement
