Page 1
The cylinder (figure 3) is connected to the tractor lift lever. Remove the clip and pin, and disconnect the cvlinder from the lift lever. Figure 3. INSTALLATION INSTRUCTIONS,’ REAR LlFT KIT MFG. NO. 1691765 FORM - 1702006 PR,NTED IN U.S.A. ,I/88...
Page 2
g. Using the front trunnion (Y; figure I), connect the cylinder and lift rod(G) to the tractor lift lever. (See figure 4.) Position cylinder and insert short leg of trunnion through it. Connect lift rod to long leg of trunnion. Be sure lift rod is positioned with flat side as shown.
Page 3
4. Insert the lift shaft (A, figure 8) into position, place bearing (B) on to each end, and secure with capscrew lockwasher and nut (C) on each side. 5. Position the rear tnmnion (D) onto thelift rod. Install the lift arm half(E) to lift shaft(F) and secure with two 3/8-16x l”capscrews, 3/8”lockwashers (G).