Initialising Sensors; Setting A Dgps Correction Mode - JRC JR-8600 Instruction Manual

4.12.8

Initialising sensors

Initialise sensors.
Set a general position and current date and time (UTC) of the sensor.
For a processor with two sensors connected, the sensors must be set individually.
In this example, sensor 1 is connected. The same procedure is applied for setting sensor 2 also.
Procedure
1. Enter a password by referencing "4.2.11. Entering a password with CODE INPUT".
Password: 1650
 
2.
INIT
QUADRANT
LAT
LON
ANT HEIGHT
YEAR
MONTH
DAY
HOUR
MINUTE
4.12.9

Setting a DGPS correction mode

A DGPS correction mode can be selected.
To perform DGPS correction, set the positioning system to "GPS".
In multi-GNSS mode, DGPS positioning cannot be performed.
If a correction mode is set in multi-GNSS mode, the positioning system is automatically set to
"GPS".
JLR-4350 does not support DGLONASS and DBeiDou. Correction data of QZSS cannot be
received.
For a processor with two sensors connected, the sensors must be set individually.
In this example, sensor 1 is connected. The same procedure is applied for setting sensor 2 also.
Procedure
1. Enter a password by referencing "4.2.11. Entering a password with CODE INPUT".
Password: 1650
 
2.
4-62

Description
Select North latitude/South latitude/East latitude/West latitude of the sensor
position.
Enter a general position (latitude) of the sensor.
Enter a general position (longitude) of the sensor.
Enter a general position (height) of the sensor.
For 2-dimensional position fixing, this height is used.
Enter the current year (UTC).
Enter the current month (UTC).
Enter the current day (UTC).
Enter the current hour (UTC).
Enter the current minute (UTC).
