Genie GTH-3512 Operator's Manual page 114

INTRODUCTION
This section provides information on the optional
interchangeable attachments, especially manufactured
for the handlers.
Use only genuine attachments, described in this
section, after having read their features thoroughly and
understood their use.
To install and remove the attachments, follow the
instructions supplied in the
C-5.4.
DANGER
When replacing interchangeable attachments, keep
any person clear of the working area.
DANGER
Mounting optional attachments, and especially the
extension jib, can change the centre of gravity of
the machine. Before handling a load, check its
weight and compare it with the values on the load
charts. The weight of the used attachment must
always be deducted from the rated payload.
■ Procedure to connect hydraulic lines:
• Couple the new attachment and lock it
• Disconnect the quick couplings
attachment locking cylinder and connect them to
the false connectors
getting dirty.
• Connect the feeding hoses of the new attachment
to the quick couplings previously set free.
When the new attachment has two hydraulic movements
like, for instance, the pole and pipe planter, a flow
selecting valve shall be installed on the machine or
the attachment. This valve will be operated by the
relevant switch in the cab.
Handler with telescopic boom GTH-3512
OPTIONAL ATTACHMENTS
"OPERATION" section, par.
hydraulically.
of the
to prevent them from
Page
Document 57.0008.7200 - 05/2007
F - 2
Courtesy of Crane.Market