Fan Power Connectors: Cpu_Fan1, Sys_Fan1; Front Usb Connectors: Jusb1, Jusb2 - MSI MS-7293 Series Getting Started

Fan Power Connectors: CPU_FAN1, SYS_FAN1

The fan power connectors support system cooling fan with +12V.
W hen connecting the wire to the connectors, always take note
that the red wire is the positive and should be connected to the
+12V, the black wire is Ground and should be connected to GND.
If the mainboard has a System Hardware Monitor chipset on-
board, you must use a specially designed fan with speed sensor
to take advantage of the CPU fan control.
Important
1. Please refer to the recommended CPU fans at Intel
consult the vendors for proper CPU cooling fan.
2. CPU_FAN1 supports fan control. You can install Core Center utility (refer
to Appendix for details) that will automatically control the CPU fan speed
according to the actual CPU temperature.

Front USB Connectors: JUSB1, JUSB2

The mainboard provides two USB 2.0 pinheaders (optional USB 2.0 bracket available)
that are compliant with Intel
increases data transfer rate up to a maximum throughput of 480Mbps, which is 40
times faster than USB 1.1, and is ideal for connecting high-speed USB interface
peripherals such as USB HDD, digital cameras, M P3 players, printers, mo-
dems and the like.
2
1
JUSB1/JUSB2
(USB 2.0)
Important
Note that the pins of VCC and GND must be connected correctly to avoid
possible damage.
®
I/O Connectivity Design Guide. USB 2.0 technology
PIN
10
1
9
3
5
7
9
Hardware Setup
®
official website or
Pin Definition
SIGNAL PIN SIGNAL
VCC 2 VCC
USB0- 4 USB1-
USB0+ 6 USB1+
GND 8 GND
Key (no pin) 10 USBOC
CONTROL
SENSOR
+1 2V
GND
CPU_FAN1
CONTROL
SENSOR
+1 2V
GND
SYS_FAN1
2-13