Hints And Tips - Electrolux TW GL4 E User Manual

STARTING A PROGRAMME
To activate the programme push the Start/
Pause button. The LED above the push
button changes the colour to red.
CHANGE A PROGRAMME
To change a programme, push the On/Off
(Ein/Aus) button to deactivate appliance.
Push the On/Off (Ein/Aus) to activate the
appliance and then set the programme
again.

HINTS AND TIPS

ECOLOGICAL HINTS
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry be-
comes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with a
coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the bot-
tom of the appliance clear.
• Use the load volumes which are specified
in the programmes chapter.
• Make sure that is good airflow in the ap-
pliance installation position.
• Clean the primary filter after each drying
cycle.
• Clean the heat exchanger filters when the
applicable indicator comes into the view
on the control panel.
• Spin good the laundry before drying.
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ-
ent locations. Water hardness has an effect
on the water conductivity and the operation
of the conductivity sensor in the appliance.
If you know the value of the water conduc-
tivity you can adjust the sensor to dry with
the better results.
AT THE END OF PROGRAMME
When the drying cycle is completed, the
symbol flashes on the display. If the Buzzer
(Signal) function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
1. Push the On/Off (Ein/Aus) button for 2
seconds to deactivate the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Important! After each drying cycle:
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
To change the sensor conductivity:
1. Turn the programme dial to available
programme.
2. Push at the same time the Dry Plus
(Trocken +) and the Anticrease (Knitter-
schutz) buttons. Hold down until one of
the symbols go into view on the dis-
play:
–
low conductivity <300 μS/
cm
–
moderate conductivity
300-600 μS/cm
–
high conductivity >600 μS/
cm
3. Push the Start Pause button again and
again until you set necessary level.
4. To memorise the setting push at the
same time the Dry Plus (Trocken +) and
the Anticrease (Knitterschutz) buttons.
WATER CONTAINER FULL —
INDICATION
By default the indication LED is always on.
It comes into the view at the end of the cy-
cle or when the water container is full.
When you use an external equipment to
drain the container, the LED can be off.
To activate or deactivate the indication:
1. Turn the programme dial to available
programme.
electrolux 33