TomTom RIDER Manual page 9

Lisbon.book Page 12 Thursday, March 1, 2007 8:39 AM
EN
Using your TomTom RIDER
Attach your headset to your helmet as shown
in the Installation Poster. Make sure you
position the microphone correctly. For best
results, don't position the microphone directly
in front of your mouth, position it just to the
side of your mouth.
Locating your current position
Your TomTom RIDER must be outside to be
able to locate your current position. The first
time you start your RIDER, it takes up to 5
minutes for the device to find your current
position.
In future, your position will be found much
faster, normally within a few seconds. If your
RIDER takes longer than 5 minutes to locate
your current position, make sure that you are
in an open place without tall buildings or trees
around you.
Your RIDER does not transmit your location,
so others cannot use it to track you while you
are driving.
Note: Before driving with your TomTom RIDER, we
recommend that you charge it fully using the home
charger.
Mounting your TomTom RIDER
Attach the RAM™ mount kit to your
motorcycle as shown on the Installation
Poster, then place your RIDER in the holder.
When you are attaching the mount kit to your
motorcycle, follow these guidelines:
• If you are unsure about attaching the
mount kit yourself, ask a professional to fit
it for you.
• Make sure that the mount kit does not
interfere with any of the controls on the
motorcycle.
• Always use the correct tools. If you use
unsuitable tools, you may damage or break
the mount kit.
• Do not overtighten nuts. You may crack
parts of the mount kit or damage your
handlebars if you overtighten the nuts.
• If you are using the u-bolt, don't forget to
put the rubber caps provided over the
exposed threads.
Damage due to modifications, improper
installation, road hazards or accidents, are not
covered. Neither RAM nor TomTom shall be
liable for any injury, loss, or damage, direct or
consequential, arising out of improper
installation, or inability to use product. Before
use, the user must determine the suitability of
the product for its intended use. The user
assumes all risk and liability, whatsoever, in
connection with the mount.
12