TomTom RIDER Manual page 8

Lisbon.book Page 11 Thursday, March 1, 2007 8:39 AM
Cardo scala-rider™ headset
A
B
C
A Microphone
B On/Off button
C Speaker
D LED
E Volume down
F Volume up
G Charging connector
Before you can use your Bluetooth headset,
fully charge the headset using the charger
supplied with the headset.
Using your TomTom RIDER
Note: Make sure you use the correct charger. There
are different chargers for your TomTom RIDER and
your headset. Using the wrong charger may damage
the device.
Fully charging the headset takes between 2
and 3 hours. When charging, the LED is a
steady red. When charging is finished, the LED
turns off.
D
When the batteries are running low, an alert
E tone is played.
F
Using your headset
To turn the headset on, press and hold the on/
G
off button for 6 seconds, until the LED flashes
blue 3 times. An ascending alert tone is
played. When the headset is on, the LED
flashes blue every 3 seconds.
To turn the headset off, press and hold the on/
off button for 3 seconds, until the LED flashes
red 3 times. A descending alert tone is played.
If you did not establish a Bluetooth connection
between your Bluetooth headset module and
your TomTom RIDER when you first turned
your RIDER on, you can establish the
connection at any time.
From the Main Menu, tap Change
Preferences. Tap Connect to headset and
follow the instructions to establish the
connection.
11
EN