Advertisement
● Prepare Elevator servo with
a 400mm Extension.
● Place the elevator and rudder servos in
position and use a drill to make the starter
hole for mounting holes for your servos into
the fuselage.
● Install the Elevator Servo using the
screws provided with your servo.
● Servo lead wires are routed
t h o u g h t h e c e n t e r p a r t
through the fuselage interior.
● Install the Rudder Servo using the
screws provided with your servo.
● Screw the servo arm plate to the top of the stock
servo arm. (Elevator servo and Rudder servo)
● Use your radio to center
your servos. Attach a servo
arm to each servo so that
the arm is vertical position.
Servo Horn
Servo Arm
12
● Prepare Rudder servo with
a 500mm Extension.
EXTENSION
M2 × 5 Tapping Screw
Rudder Linkage
● Adjust the length of the rod
so that the surface is neutral
and secure the ball link.
Ball Link
● Use the inside
hole.
! The the raised ball link on
the servo side.
M2 Washer
M2 Nut
M2 × 12 Hex head bolt
Fuselage
Elevator Linkage
! The the raised ball link on
the servo side.
Elevator Rod
Ball Link
M2 × 10 Hex head bolt
M2 × 10 Hex head bolt
Ball Link
M2 Nut
M2 Washer
M2 Nut
M2 × 10 Hex head bolt
Rudder Rod
Ball Link
M2 × 10 Hex head bolt
Rudder
M2 × 12 Hex head bolt
● Use the inside
hole.
M2 × 12 Hex head bolt
Raised Ball Link
M2 Washer
M2 Nut
Advertisement
