Table of Contents
Advertisement
Mesh Enabled Architecture
WMC6300 Windows Users Guide
Control Channel Configuration
There are four channels available for MEA network communications. The Network Administrator
can map the four available Physical channels to three Data channels and one Control channel.
The Data channels will be used for data transmission between subscriber devices, infrastructure
devices, and the network.
The Control channel is designated for internal MEA communication. By default, it is set to the
physical channel 3 (2.47 GHz).
Changing Control Channel
A user should never change the channel mappings unless specifically instructed to do so by the
Network Administrator. Clicking on the Change Control Channel button prompts the user to
enter the password required to change the control channel configuration. If the user is
authorized to change the control channel, the password will be supplied by the Network
Administrator. Enter the password and click on the OK button.
Figure 51.
Password Protection Panel
ATTENTION: Any unauthorized change can cause the WMC6300 to stop communication with
the network and other subscriber devices.
37
Advertisement
Table of Contents
