Table of Contents
Advertisement
Advanced Tab
In the MagicLan Utility, access the Advanced tab by clicking
Networks tab, then clicking the Advanced tab in Profile Management.
Edit the fields in the Advanced tab of Wireless Networks to configure the profile.
Make sure to also edit the
Transmit Power
Selects the transmit power level for 80211b/g. Actual transmit power
Level
may be limited by regulatory domain or hardware limitations.
Power Save
Specify:
Mode
•
•
•
Network Type
Specifies the network as either infrastructure (access point mode) or
ad hoc.
802.11b Preamble
Specifies the preamble setting in 802.11b. The default setting is
& Long
in the 802.11b frames. The adapter can only use short radio headers
if the access point supports and uses them. Set to
override allowing short frames.
Wireless Mode
Specifies 2.4 GHz 54 Mbps or 2.4 GHz 11 Mbps operation in an access
point network.
The wireless adapter must match the wireless mode of the access
point it associates to.
General
and
Security
tabs.
Maximum
mode causes the access point to buffer incoming
messages for the wireless adapter.
periodically polls the access point to see if any messages are
waiting.
Normal
uses maximum when retrieving a large number of
packets, then switches back to power save mode after
retrieving the packets.
Off
turns power saving off, thus powering up the wireless
adapter continuously for a short message response time.
(access point mode), which allows both short and long headers
New
or
Modify
on the Wireless
The adapter up
Long Only
Short
to
Advertisement
Table of Contents
