Nokia Exx-1 series User Manual page 88

file:///C:/USERS/MODEServer/lkatajis/11051417/ra-6_maxi/en/issue_1/ra-6_maxi_en_1.xml file:///C:/USERS/MODEServer/lkatajis/11051417/ra-6_maxi/en/issue_1/ra-6_maxi_en_1.xml
WLAN security settings
Select Access points Options
>
select an access point and Options
In the access point settings, select
mode > WEP.
The wired equivalent privacy (WEP) encryption method
encrypts data before it is transmitted. Access to the
network is denied to users who do not have the
required WEP keys. When the WEP security mode is in
use, and your device receives a data packet not
encrypted with the WEP keys, the data is discarded.
In an Ad-hoc network, all devices must use the same
WEP key.
Select WLAN security settings
WEP key in use — Select the desired WEP key.
•
Authentication type — Select
•
WEP key settings — Edit the settings for the WEP key.
•
EAP
Select Tools Settings
> >
points.
The EAP (extensible authentication protocol) plug-ins
are used in wireless networks to authenticate wireless
devices and authentication servers, and the different
EAP plug-ins make possible the use of various EAP
methods (network service).
You can view the EAP plug-ins currently installed in your
device (network service).
88
1. To define the EAP plug-in settings, select
New access point
uses WLAN as a data bearer.
New access point, or
>
> Edit.
2. Select 802.1x
WLAN security
3. Select WLAN security settings
EAP EAP plug-in
>
To use an EAP plug-in when you connect to a WLAN
using the access point, select the desired plug-in and
Options > Enable. The EAP plug-ins enabled for use
with this access point have a check mark next to them.
To not use a plug-in, select
To edit the EAP plug-in settings, select
To change the priority of the EAP plug-in settings, select
Options Raise priority
>
and from the following:
before other plug-ins when connecting to the network
with the access point, or
Open or Shared.
use this plug-in for network authentication after
attempting to use other plug-ins.
See the device help for more information on EAP
plugins.
Connection Access
Data call settings
> >
Select Tools
>
call.
To set the time-out period after which data calls
automatically end if no data has been transferred,
select Online time. Select
yourself or Unlimited
until you select
Page 88 Page 88 Jan 8, 2007 1:39:30 PM Jan 8, 2007 1:39:30 PM
Options
>
and define an access point that
or WPA/WPA2 as the security mode.
WPA/WPA2
> >
settings.
Options > Disable.
Options > Edit.
to attempt to use the plug-in
Options Lower priority to
>
Settings Connection Data
> > >
User defined to enter the time
to keep the connection active
Options > Disconnect.