Nokia Exx-1 series User Manual page 61

file:///C:/USERS/MODEServer/lkatajis/11051417/ra-6_maxi/en/issue_1/ra-6_maxi_en_1.xml file:///C:/USERS/MODEServer/lkatajis/11051417/ra-6_maxi/en/issue_1/ra-6_maxi_en_1.xml
message from your service provider. This might reduce
the number of settings you need to enter yourself.
The available options may vary. Some or all access
points may be preset for your device by your service
provider. You may not be able to add, edit, or delete
access points. Contact your service provider and e-mail
service provider for more information on access points
and their settings.
Set up an internet access point for
data calls
1. Select Tools
> >
Access points.
2. Select Options New access
>
existing access point as a basis for the new one,
select Use existing settings. To start with an empty
access point, select Use default
3. Define the following settings.
Connection name
•
the connection.
Data bearer — Select
•
(GSM).
Dial-up number — Enter the modem telephone
•
number of the access point. Use + before
international numbers.
User name — Enter your user name if required
•
by the service provider. User names are often
case-sensitive and provided by your service
provider.
Prompt password
•
password each time you log into a server or
to save the password in your device memory and
automate the login.
Password
•
the service provider. The password is often case-
sensitive and provided by the service provider.
Authentication
•
password always encrypted or
your password encrypted when possible.
Homepage
•
you want to display as the home page when you
use this access point.
Data call type
•
ISDN
Maximum data speed
•
Settings Connection
> >
to the transfer speed. If you select Automatic, the
data transfer rate is determined by the network
point. To use an
and may be affected by network traffic. Some
service providers may charge more for higher
data rates.
settings.
4. After defining the basic settings, select
Advanced settings
— Enter a descriptive name for or Back
Data call or High speed
Set up an internet access point for
packet data (GPRS)
1. Select
Access
2. Select
existing access point as a basis for the new one,
select
— Select Yes to enter your
access point, select
No
3. Define the following settings.
Page 61 Page 61 Jan 8, 2007 1:39:30 PM Jan 8, 2007 1:39:30 PM
— Enter your password if required by
— Select Secure to send your
Normal to send
— Enter the web address of the page
— Select Analog, ISDN v.110, or
v.120.
— Select the limit to apply
Options
to define the advanced settings
to save the settings and exit.
Tools Settings Connection
> > > >
points.
Options New access point. To use an
>
Use existing settings. To start with an empty
Use default settings.
>
61