Vertical Stabilizer - FUTABA SkyLeaf Classic Instruction Manual

2. Installation of Elevator Servo
1 1
● For S.BUS connection Elevator CH2
servo to elevator.
2 1
● Pull out the wiring
from this hole.
● Attach the servo
in the direction of
the figure.
6

Vertical stabilizer

1. Installation of Vertical stabilizer
1 1
● Insert the Vertical stabilizer into the
fuselage. Mark the Vertical stabilizer.
1 2
● Cut the film at the joint along the mark.
Do not cut balsa of the vertical stabilizer.
14
CH2
Elevator
● Drill a hole in the wood
s c r e w i n t h e s e r v o
mount. Fix the servo
with 4 wood screws.
j g
3
● Linkage as shown. Use your radio to center
your servos. Attach a servo horn to each
servo so that the horn is vertical position.
1 3
● Make sure that the Vertical stabilizer
stands perpendicular on the fuselage.
1 4
● Adhere the Vertical stabilizer with CA glue.