Water Inlet - Electrolux Swissline SL EWF 1880 User Information

Water inlet

Attention!
• An inlet hose is supplied and can be found inside the machine drum.
• Do not use the hose from your previous machine to connect to the
water supply.
• This appliance must be connected to a cold water supply.
1. Open the porthole and extract the inlet hose.
2. Connect the hose with the angled con-
nection to the machine.
Important!
Do not place the inlet hose down-
wards. Angle the hose to the left or
right depending on the position of your
water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a
3/4" thread.
Always use the hose supplied with the
appliance.
Installation should comply with local wa-
ter authority and building regulations' re-
quirements.
A minimum water pressure of 0.05 MPa
(0.5 bar) is required for safe operation of
the appliance.
If you cannot make the cold water con-
nection direct from the rising mains, you may be able to operate the appli-
ance from your cold water storage system.
There should be a minimum distance of 5.02m (16.5 ft) between the appli-
ance's inlet and the bottom of the water storage tank.
39