Examples Of Setting - Toshiba TOSVERT VF-S15 Instruction Manual

5. Examples of setting

This chapter gives some examples of setting.
Note that the settings described below are examples and there are other ways to set a function
for some examples.
● Examples of the setting of the combined terminal function
Example 1: Performing 2 functions by 1 terminal.
Example 2: Performing 2 functions by 1 terminal.
Example 3: Performing 3 functions by 1 terminal.
Example 4: Output signal by logical product of 2 functions.
● Examples of the setting of the relay sequence function
Example 5: Operation with a combination of 2 input signals
Example 6: Operation with push type switch.
Example 7: Automatic stop by some conditions.
Standby signal is connected with Terminal F (Forward run command). (F+ST)
Standby signal is connected with Terminal R (Reverse run command). (R+ST)
Performing standby and forward run command by the Terminal S1. (ST+F)
Performing standby, forward run command, and preset-speed command 1 by the
Terminal S1. (ST+F+SS1)
Output the signal on the condition of detecting both a low-speed signal and a small
current signal from Terminal OUT.
Forward run: Either input terminal is turned on.
Reverse run: Both input terminals are turned on.
Stop : Both input terminals are turned off.
Automatically stop on the condition of 5Hz or less of output frequency and 120% or
more of output current.
- 12 -
E6581865