Inline Gage Transmitter Orientation - Emerson Rosemount 2051CF Series Quick Installation Manual

Quick Installation Guide
00825-0200-4101, Rev EA
June 2010
E. Inline Gage Transmitter Orientation
The low side pressure port (atmospheric reference) on the inline gage transmitter is located
in the neck of the transmitter, behind the housing. The vent path is 360° around the
transmitter between the housing and sensor. (See Figure 3.)
Keep the vent path free of any obstruction, including but not limited to paint, dust, and
lubrication by mounting the transmitter so that the contaminants can drain away.
Figure 3. Inline Gage Transmitter
S 2: T
TEP AGGING
Commissioning (Paper) Tag
To identify which device is at a particular location use
the removable tag provided with the transmitter. Ensure
that the physical device tag (PD Tag field) is properly
entered in both places on the removable
commissioning tag and tear off the bottom portion for
each transmitter.
NOTE
The device description loaded in the host system must
be at the same revision as this device. The device
description can be downloaded from
www.emersonprocess.com/rosemount.
S 3: C
TEP ONSIDER
To improve field access to wiring or to better view the optional LCD display:
1. Loosen the housing rotation set screw.
2. First rotate the housing clockwise to the desired location. If
the desired location cannot be achieved due to thread limit,
rotate the housing counter clockwise to the desired location
(up to 360° from thread limit).
3. Retighten the housing rotation set screw.
H R
OUSING OTATION
Rosemount 2051
Low side pressure port
(atmospheric reference)
COMMISSIONING TAG
Device ID:
0011512051010001440-121698091725
PD Tag:
Tear Here
COMMISSIONING TAG
Device ID:
0011512051010001440-121698091725
PD Tag:
Housing Rotation Set Screw
(5/64-inch)
7