Using The Pause Feature For Dialing; Using Line Transfer Feature; Using The Page / Handset Location Feature; Using The Headset Feature Pages - BellSouth A50 Installation Manual & User Manual

Using The Pause Feature For Dialing

The "R/P" button is used to insert a temporary pause during a dialing sequence. Program-
ming in a pause will cause the phone to wait two (2) seconds before dialing additional
numbers. This feature may be used when it is necessary to dial an access code (9, for
example) and wait for a second dial tone before you can dial an outside number. Press
the "R/P" button at the required point during the memory storage process to program a
pause.
When dialing an international number for example (i.e. 011-555-55-555-5555), some tele-
phone company systems will not register the entire number entry without a pause between
the prefix numbers. You may have to dial 011- "R/P" button, dial 555- "R/P" button. This
allows adequate timing for the phone number to register with the telephone company's
system and complete the call.

Using Line Transfer Feature

If extra handsets are set to the base unit:
1. During a phone conversation, press the "SEL" button and the handset number
you wish to transfer to. The line will be on HOLD and will make an audio sound
on the other handset.
2. On the other handset you can press
receiving the transfer ring.
3. Press the
does not want to take the call during the transfer ring.
4. If the two handsets do not respond within 60 seconds, the line will disconnect
automatically.

Using The Page / Handset Location Feature

Send a page signal from the base to the handset or to locate the handset.
1. Press the
handset.
2. Press the
3. If you do not press the
30 seconds then end the paging automatically.
Using The Headset Feature
You can use this telephone hands-free when you connect a 2.5mm headset (purchased
separately). To connect, plug the headset into the HEADSET JACK at the bottom of the
handset.
While in the Headset Mode, the volume of the headset is controlled by the telephone
and the handset's earpiece and microphone are disconnected. Follow the procedures
discussed in ANSWERING A CALL and PLACING A CALL
receive and place a call.
1
button to return the connection back if the other handset user
/PAGE button located on the base of the telephone to page the
/PAGE button once more to cancel the paging feature.
/PAGE
to answer the call automatically after
button again, the handset will ring for about
(See pages #17 & 18)
when you