Setting Up A Mobile Interface - Technicolor TG672 Setup And User Manual

3.5.1 Setting up a Mobile Interface

Procedure
To set up the mobile interface complete the following steps:
Step 1: Start a CLI session.
Step 2: Add a mobile interface
Step 3: Configure a mobile interface
Step 4: Attach the mobile interface
Step 1: Start a CLI session
For more information, see
Step 2: Add a mobile interface
Execute the following command:
:mobile ifadd intf=<string>
With the following parameters:
intf

The name of the mobile USB interface.
Example:
:mobile ifadd intf=mobile_usb
With the command mobile ifdelete intf you can delete a mobile USB interface.
Step 3: Configure a mobile interface
Execute the following command:
:mobile ifconfig intf=<string> [pin=<password>] [puk=<string>]
With the following parameters:
intf

The name of the mobile USB interface.
pin

This parameter represents the PIN code of the SIM card.
puk

This parameter represents the PUK code of the SIM card.
Only if you failed three times to attach the mobile interface using a wrong (unique) PIN code, the PUK code will
be used instead of the PIN code. It is advised to always fill in this parameter.
apn

The Access Point Name (APN) used to access the packet switched services of the operator. The APN syntax must follow
the rules specified in the standard 3GPP23.003. It is recommended to always specify this value. If not specified, the
network will try to fill in the APN but may fail.
E-DOC-CTC-20100728-0008 v2.0
"4.3 The Command Line Interface (CLI)" on page
[apn=<string>] [mode=<{automatic|manual}>]
[operator=<number{0-99999}>] [technology=<{2G|3G}>]
[initcommand=<string>]
3 MANUAL INSTALLATION
49.
35