Pushing The Rider By Hand - Snapper 360Z Zero Turn Rider Operator's Manual

Pushing the Rider by Hand

1. Disengage the PTO, lock the ground speed levers into
their START/PARK positions, turn the ignition OFF,
remove the key, and wait for all moving parts to stop.
2. To disengage the transmissions, move the roll release
levers (A or B, Figure 4, depending on model), into the
PUSH position as shown.
3. Pivot the ground speed levers in from the START/
PARK position to the neutral 'N' position to disengage
the parking brake.
The rider can now be pushed by hand.
4. After moving the rider, re-engage the transmissions by
moving the roll release levers back to the DRIVE posi-
tion.
DO NOT TOW RIDER
Towing the unit will cause transmission dam-
age.
• Do not use another vehicle to push or pull
this unit.
• Do not actuate the transmission release
valve lever while the engine is running.
16
A
WARNING
DO NOT disengage the transmissions and
coast down slopes. DO NOT use Roll Release to
disengage the transmissions unless machine motion
can be controlled and engine is off.
B
Figure 4